Firmware Upgrade for CO2 Laser Engravers
This upgrade is exclusive to CO2 laser engraver cutting machines with integrated auto-focus sensors. You can check the motherboard version on your machine, download the correct file, and follow the steps below for an upgrade in RDWorks.
If you do not have RDWorks installed yet, please go to https://omtechlaser.com/pages/software-download.
By upgrading the motherboard firmware, the machines are better protected from possible sensor glitches and are capable of performing a smoother curving movement.
If you do not have RDWorks installed yet, please go to https://omtechlaser.com/pages/software-download.
By upgrading the motherboard firmware, the machines are better protected from possible sensor glitches and are capable of performing a smoother curving movement.
1. Use RDWorks to operate
2. Upgrade your firmware!
Enhance your experience with a firmware upgrade for your CO2 laser engravers!
*Please contact our cs team if you have any doubts!